This dialog is used to define outputs for the states in a state diagram. Outputs are listed vertically down the left side of the table while states are listed along the top of the table. Each cell in the table can be checked to configure the state listed in that column to turn on the output in that row. Outputs can be moved using the up and down arrow buttons on the left hand side of the dialog. This affects the order of the outputs on the state diagram's symbol. States can be moved using the left and right arrow buttons on the left hand side of the dialog. This affects the order of the states on the state diagram's symbol. Once states have been explicitly ordered by the user they will remain in that order and new states added to the state diagram will appear below the ordered states. New outputs can be added using the Add Output button. Outputs can be renamed by selecting a row then using the Rename Output button. Outputs can be removed by selecting a row then using the Remove Selected button. Changes to the state diagram will not take effect until OK is clicked. If Cancel is clicked the state diagram and project as a whole will not be altered. |